Andy
March 28th 04, 08:09 PM
I have a Harrier CB HQ Homebase it indicates changing channel but the radio
stays on one channel on receive, I can tune the vco-can to receive on any
channel 1-40 but I can't change channel with the selector. The voltage on
TP1 is 6.5 volts on RX and TX it does not change I cannot adjust the vco
down to 4 volts on channel 40 the voltage just stays the same. anyone know
what the problem might be or where I might look first?
Thanks
Andy
stays on one channel on receive, I can tune the vco-can to receive on any
channel 1-40 but I can't change channel with the selector. The voltage on
TP1 is 6.5 volts on RX and TX it does not change I cannot adjust the vco
down to 4 volts on channel 40 the voltage just stays the same. anyone know
what the problem might be or where I might look first?
Thanks
Andy