You may have fried something. On the other hand, maybe the power supply is
failing. If trying it on a new power adaptor does not help, you may need to
have a technician look at it.

If trying it on a new power adaptor does not help, you may need to have a
technician look at it.

I understand the audio is distorted on battery operation, too. On the other
hand, if both the adapter and the batteries were bad... Weak batteries will
give distorted audio.

I know that a even new adapter will give a slight hum on CW and SSB reception.
It also puts hum bars on FAX pix. Because the D cells don't last long, I built
a little filtered power supply for my DX-392.

I also don't trust wall adapters. A ham friend had his shack burned out due to
the failure of one of those. If they run warm when they are in use, they might
be okay. I had one for a video switch that ran too hot to touch.

Using house junction boxes, each with a socket and a switch, plus a very low
rated fuse, I felt safe in running a couple of units full time.

But for the 392 with bad audio even on FM, the PLL may be trying to unlock. The
AA cells may be weak.

Try the easy stuff first.

Bill, K5BY

WShoots1 wrote:
If trying it on a new power adaptor does not help, you may need to have a
technician look at it.

I understand the audio is distorted on battery operation, too. On the other
hand, if both the adapter and the batteries were bad... Weak batteries will
give distorted audio.

As will an adapter thats simply not making good connection at the plug/jack.

=BM

As will an adapter thats simply not making good connection at the plug/jack.


Good point. My DX-392 has crappy jacks. Someday I'm going to get in there and
maybe replace the power and antenna jacks, which are constantly used. I think
the dual/stereo audio output jack is sick, too.

Bill, K5BY

You will probably have to put new jacks in a different location an wire to
them. The stock ones are soldered to the board.
"WShoots1" wrote in message
...

Good point. My DX-392 has crappy jacks. Someday I'm going to get in there
and
maybe replace the power and antenna jacks, which are constantly used. I
think
the dual/stereo audio output jack is sick, too.

Bill, K5BY

You will probably have to put new jacks in a different location an wire to
them. The stock ones are soldered to the board.

Thanks, CW. That must have been what I'd found out. I knew something had made
me put off changing them out. :-)

If I ever come up with a clever solution, I'll pass it along.

73,
Bill, K5BY