View Single Post
  #3   Report Post  
Old November 21st 04, 04:10 AM
Dale Parfitt
 
Posts: n/a
Default


"Scott" wrote in message
...
Stripping magnet wire? You mean like after making coils and wanting to
solder them to something? Why bother? Just put a blob of solder on
your iron's tip and put the end of the magnet wire into the solder blob.
After several seconds, the insulation will melt off and the wire end
will be tinned with solder and ready for install!

Scott
N0EDV

This is only true for some types- like Belden Soldereze. Many others will

not be touched by heat- formvar for example.

Dale W4OP