Thread: Rtty Protocol
View Single Post
  #9   Report Post  
Old February 12th 05, 06:21 PM
Dr. Anton T. Squeegee
 
Posts: n/a
Default

In article ,
says...

I am using Ham Scope and Mmtty to decode RTTY with my sound card. It
works fine for hame radio operators but I have found RTTY on non-ham
frquencies and all I get is garbage. For example, there is an RTTY
signal at approximately 2.042 MHZ at 1100 UTC on the West Coast and
all that displays is random characters. I suspect it has something to
do with the protocol or baud rate settings. Anyone know what they
might be? Not sure if this is maritime station or not. Thanks.


Are you certain the signal even is RTTY? I've run across a number
of signals that sound like RTTY, but are in reality anything but.

Also, as others have pointed out, you may be picking up an
encrypted signal.

Keep the peace(es).


--
Dr. Anton T. Squeegee, Director, Dutch Surrealist Plumbing Institute.
(Known to some as Bruce Lane, ARS KC7GR,
kyrrin (a/t) bluefeathertech[d=o=t]calm --
www.bluefeathertech.com
"If Salvador Dali had owned a computer, would it have been equipped
with surreal ports?"