View Single Post
  #2   Report Post  
Old March 8th 05, 07:19 PM
Mac
 
Posts: n/a
Default


"John KB5AG" wrote in message
...
I have a Uniden BC890XLT that seems to work normally, but receives

nothing.
A Google search comes up with a similar problem to mine, but I don't see a
solution.
There's an IC, a Sharp IR3MO3A which is running super hot. It's switching
regulator IC, but I'm not sure what its purpose is, since most of the set
runs from the 5 and 8v linear regulators in the power supply.
Anyone had any experience with this? Is there a schematic anywhere
available for this?

Thanks,
John


John, the IR3MO3A is IC 12.

Program 162.400 and the voltages should measure;

Pin 1 - 12.85
Pin 2 - 0
Pin 3 - 0.54
Pin 4 - 0
Pin 5 - 1.27
Pin 6 - 12.85
Pin 7 - 12.85
Pin 8 - 12.85

There is a capacitor to ground off pins 1 and 6 that may have become leaky.
C63 and C65 are both located near the I.C.
Pin 6 provides the input voltage to I.C. 7, an L78MO5CV. If this regulator,
or some of its circuitry, is shorted or leaky this drain may be causing the
excess heat on IC 12.

Hope this helps you. Keep us posted!

Mac