QRT for decades now getting the urge to go online again
On Mar 19, 11:10 am, Bill Horne wrote:
If you have the choice, I recommend switching to BNC or N connectors:
they're much easier to assemble, and have far less loss.
Hadn't thought about the loss perspective. I don't care for the
PL-259's tendency to not make good connection on the pin after a few
insert cycles and I hear that N connectors are a bit better. But I've
not considered BNC, at least for HF work. I use them on VHF/UHF but
my power levels are well under 50W and SWR's are all fairly reasonable
(under 3:1).
Am I safe using BNC at 100W on HF with SWR's in the 5:1 range? What is
the breakdown voltage of a BNC connector?
-= Bob =-
|