View Single Post
  #14   Report Post  
Old April 22nd 08, 05:16 AM posted to rec.radio.amateur.antenna
Roy Lewallen Roy Lewallen is offline
external usenet poster
 
First recorded activity by RadioBanter: Jun 2006
Posts: 1,374
Default Use of type 31 ferrite as coax common mode choke

J. Mc Laughlin wrote:
I looked through saved messages and the only reference to type 31 ferrite
(Fair-Rite) was in March of 2005. That reference had to do with ignition
wires.

Recommendations for HF choking ferrites have centered on the 70 series with
type 43 being favorably recommended for the upper portion of HF and VHF.
However, Fair-Rite seems to be recommending type 31 for HF. See Figure 26
in:
http://www.fair-rite.com/newfair/pdf/CUP%20Paper.pdf

Am I missing something? It seems to me that for the purpose of choking
common mode current (on the outside of the outer conductor of coax) from 3
to 25 MHz one should prefer the use of type 31. This is a receiving
application with a long run of coax.

73, Mac N8TT

P.S. I will also appreciate ideas about places to purchase ferrite in
addition to Mouser.


A fairly brief look at the graphs (Figs. 6 - 8) shows that type 31 has
roughly the same or a little higher total complex permeability than 73
over most of the lower HF range and same or higher than 43 on up to 100
MHz. So it should be a good ferrite to use for very wide band
applications. However, Table 1 shows that it's available in large parts
only. Type 43 is very widely available in a wide variety of sizes, so
you might have a lot more luck getting cores of the sizes you need in
type 43.

Roy Lewallen, W7EL