ARC-5 Tuning Shaft Adapters
ORIGINAL MESSAGE:
On 18 Sep 2006 21:03:02 -0700, "
wrote:
Does anyone have or can they direct me to a couple of "splined"
tuning shaft adapters that fit the ARC-5 Command Set receivers?
I'd like to adapt some of the ganged variable capacitors from
those sets into some homebuilt equipment...lovely antibacklash
gear reduction on them.
------------ REPLY FOLLOWS ------------
Agreed, those are among the best variable capacitors ever made.
My first radio in 1957 was an ARC-5 a friend gave me. It had a shaft
made from a piece of 1/4 inch copper tubing, carefully drilled out so
it was a very tight force fit. No glue, set screws or anything like
that, just a very tight fit that had to be driven on with a hammer. I
used that RX for a couple of years and the shaft performed perfectly.
Hope this helps.
Bill, W6WRT
|