View Single Post
  #10   Report Post  
Old April 8th 07, 08:54 AM posted to rec.radio.amateur.antenna,rec.radio.amateur.misc,rec.radio.amateur.policy
[email protected] mike-c@bulldoghome.com is offline
external usenet poster
 
First recorded activity by RadioBanter: Mar 2007
Posts: 7
Default RG-6 Coaxial Cable for Ham use

On Apr 8, 1:05 am, "Ralph Mowery" wrote:
"Dave Heil" wrote in message

rthlink.net...



Tam/WB2TT wrote:


I might point out to Dee that the RG-6 I see is indeed meant for outdoor
use. Our local dish installers us it as their standard feedline.


Of the few samples that I looked at, the black RG6 was outdoor rated, the
white jacketed was not. Kind of makes sense. Didn't see any power ratings
at the Belden site, but I seem to recall seeing ratings in the few
hundred W range.


RG-6 will take the legal limit on at least 80 and 160m and probably on
40m. It is available in direct burial type. The new, weather-proof crimp
on connectors are wonderful.


Several companies make or sell the PL-251 to F connector adaptors.


W8JI had some informative technical posts on the subject on the topband
reflector a few months back.
Dave K8MN


I would think the power level would be more voltage limiated. Most of the
rg6 is rated around 300 to 350 volts. This is about 1200 watts on a matched
line. derate for a swr of say 3 or 4 to 1 and you get to run about 300 to
400 watts into it,


personally I dont consider it for ham work it appears too far out of
spec and cannot be gaurentead to be outdoor rated ie if ordered and
the supplier does not have they may send the wrong type. In a
warehouse you pay peanuts get monkeys. power wise take the 300 watts
and 1/2 it for safety limits.