View Single Post
  #4   Report Post  
Old August 28th 08, 02:33 AM posted to rec.radio.amateur.equipment
Ralph Mowery Ralph Mowery is offline
external usenet poster
 
First recorded activity by RadioBanter: Jul 2006
Posts: 702
Default Need wire identification for Alliance Rotor motor


"rebdaniel" wrote in message
...

Saw a previous posting where a user was helped with a different model
than mine a couple of years ago.

I've got an Alliance U-110 Tenna Rotor and the schematics are missing
for the in house controller. Four terminals, labeled 1-4, no idea how
they connect with with the wires. I inherited a system already in use,
and the wires which are in place are red, green, black and white. Any
ideas about which goes to which terminal?

Sadly uneducated,
RebDaniel

The wire colors mean nothing. If you can look at the rotator, then the same
number on the rotator goes to the same number on the house unit.

I usually use the colors of the resistor code when wiring up things, just
start with the lowest color wire and go up.
I doubt anyone else does this.