View Single Post
  #13   Report Post  
Old August 24th 08, 07:59 AM posted to rec.radio.amateur.antenna
Sal M. Onella Sal M. Onella is offline
external usenet poster
 
First recorded activity by RadioBanter: Jul 2006
Posts: 442
Default How do you get a ground rod to 6 feet ?


Dave Lemper wrote in message
...
The soil in central Texas is called Caliche with a lot of clay,
CaCO3 & shale. Attempting to drive in a ground rod
yielded only a mushroom on top & blisters on me.
Local tool rental place has concrete bits, but maximum
length of 18 inches. Possibly longer bits are available in
a larger city.

Renting a back hoe is out.
Any suggestions appreciated.
Dave WB3DWE




Here's a snippet from the state of Washington's website that quotes the NEC:

NEC 250-52 (c)(3) (1999 edition) requires that ground rods "be driven to a
depth of not less than 8 feet
(2.44m) except that, where rock bottom is encountered, the electrode shall
be driven at an oblique angle
not to exceed 45 degrees from the vertical or shall be buried in a trench
that is at least 2½ ft. (762mm)
deep."

The requirement is that the rod be driven to a depth of 8 feet. If the rod
cannot be driven then there is a
choice of either driving it at a 45-degree angle or laying it in a trench
that is not less than 2½ feet deep.

http://www.lni.wa.gov/tradeslicensin...ts/elc0210.pdf.

I browsed some newer discussions and found nothing newer to be at variance
with the quoted material. The current NEC is $75 if snippets won't do ya'.

http://www.nfpa.org/itemDetail.asp?c...RL=Pub licati
ons/

You need 25 ohms maximum rersistance (three-point method) to say you have a
good ground.