View Single Post
  #1   Report Post  
Old March 19th 12, 06:20 PM
JohnD JohnD is offline
Junior Member
 
First recorded activity by RadioBanter: Mar 2012
Posts: 2
Default Mods - Please Delete This. Accidental Double Post

Hello everyone...

I have just purchased (10 bucks) a Lafayette HA-230 receiver.

Person I purchased it from says that it belonged to his dad and it worked fine when his dad used it seven years ago.

His dad died and he has had it stored for the seven years.

He says that he plugged it in and it lights up but he could not get it to receive. It did not appear to me however that he knew how to use it.

I would like some advice from you guys here that have used/worked on this model receiver.

After sitting for seven years, what should I do to the unit before trying to use it myself?

I did plug it in and the lights do come on, but I did not hook it up to an antenna. I wanted to check for scratchy switches on the front panel.

I found a couple that need to be cleaned and I read in a post last night that the band selector switch should be cleaned as well.

I am also wondering if there are any "known caps" (or other parts) that should be replaced right off the bat?

I am not a tech but have done minor repairs to CB radio equipment for many years. Thinks like replacing drivers, finals, caps, protection diodes, LED panels and the like.

I have no injection equipment or scopes, just my trusty VOM's. And of course, a dozen or so good soldering irons.

May I please have your comments/advise/suggestions on obvious things to do before I start using the radio?

Thank you very much for your time and help,
John

PS - What specs would be ok to use for an antenna just for a testing and working on before I put up a full blown 100' antenna?

Last edited by JohnD : March 19th 12 at 06:40 PM Reason: Accidental Double Post