Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
Old February 25th 04, 07:31 AM
Bill Meara
 
Posts: n/a
Default Converting sig gen to solid state

I have an old Heath SG-6 signal generator. It uses two triodes.
I'd like to convert it to solid state. The switched coils, varible cap
and dial mechanism are very nice. Any suggestions on what kind of
oscillator circuit I should use? I imagine the difficult part will
be coming up with a feedback circuit that will cover the 160 kHz to 50 Mhz.
Any ideas? Has anyone seen any articles on this kind of conversion?
By going solid state and adding a few buffer stages I'm hoping I could make
this thing a lot more stable. 73 Bill M0HBR CU2JL N2CQR
http://planeta.clix.pt/n2cqr
Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
FS: Solid State 866's and EV Microphone Dave Hollander Equipment 0 May 21st 04 05:35 AM
Converting sig gen to solid state Bill Meara Homebrew 20 March 14th 04 06:44 PM
Any Good Solid State XCVR for AM? Paul Clay Equipment 42 November 28th 03 07:27 AM
How to solid state a tube HFO? John Ely Boatanchors 0 October 24th 03 01:46 PM
1N1239 Solid State replacement for 5R4 tube AA5JJ Boatanchors 0 October 10th 03 03:10 PM


All times are GMT +1. The time now is 11:27 AM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 RadioBanter.
The comments are property of their posters.
 

About Us

"It's about Radio"

 

Copyright © 2017