|If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.|
||Thread Tools||Display Modes|
Bearcat BC 145XL repair
Have you measured the voltages on the voltage regulator I.C.? Might be a
good place to begin since it is running too hot. A short within the I.C.
itself can cause that.
StoneAgeMan wrote in message
Does anyone know where to get a service manual/schematic for the Uniden BC
145XL. I tried emailing Uniden but got no reply on it.
I believe it is the same scanner as the Cobra SR900.
The unit I have was in storage for about 10 years. When power was applied
briefly flashed 'LOCKED' and then died. The voltage regulator is getting
hot and some of the larger electrolytics look corroded, but I would prefer
to trace the circuit rather than do a 'shotgun' repair.
Any help kindly received,
inbox at sholtz dot port5 dot com
|Thread||Thread Starter||Forum||Replies||Last Post|
|Bay Area/Central Valley Repair Shop Needed||PTS1||CB||0||September 11th 04 08:39 PM|
|Kenwood & Yaesu Repair Service||John||Equipment||0||January 17th 04 11:58 AM|
|Kenwood 930/940 Repair Service||John||Equipment||0||January 11th 04 12:35 AM|
|Export and Domestic Radio Repair AM/FM/SSB||West Coast Radio||CB||4||August 12th 03 06:49 PM|
|Headphone Repair Question||WavyDave||Homebrew||8||July 10th 03 06:00 AM|