|If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.|
||Thread Tools||Display Modes|
FS Palomar VLF Converter
FS is a Palomar Engineers VLF Converter. These converters are used to allow
low frequencies from 10 to 500KHzs on receivers and transceivers that don't
go that low.
It is operated off of a 9 volt transistor battery and is easy to use. Below
are the directions for use:
Connect an antenna to the "10-500 KHz Antenna" connector. Connect a
shielded cable from the "3.5-4 MHz Out" connector to a receiver that tunes
3500-4000 KHz. Clip a 9-volt transistor battery to the leads and slip it
into the holder on the converter. Turn the switch to "ON".
Tune the receiver to 3500 KHZ where a strong carrier should be heard -
this is the converter local oscillator. Tune the receiver up from 3500 kHZ.
The VLF signals heard will be at the dial reading less 3500 KHZ.
This converter is used and in very good condition. Price is $45 plus
Thanks, Charlie Hugg, K5MBX
See my Signal/One, Collins & Drake
Photo Galleries and my Hallicrafters
Virtual Museum at http://hug-a-bug.com
|Thread||Thread Starter||Forum||Replies||Last Post|
|FS Palomar VLF Converter||Charlie Hugg||Boatanchors||0||February 24th 06 03:53 AM|
|How to fix distorted sideband audio on a Palomar 300 Elite||Scooby Don't||CB||2||July 3rd 05 09:05 PM|
|FA: Palomar VLF Converter||W8KZW||Swap||0||February 18th 05 02:19 PM|
|WARNING Passport on Liypn's AC converter||tommyknocker||Shortwave||15||December 4th 04 03:59 AM|
|Palomar 300A Amp Help...||Toll Free||CB||1||July 15th 03 06:40 AM|