Dee, the issue is that many old hams know CW, but cannot operate most
new digital modes. But if I understand what you are saying, if a 20 WPM
Extra Class ham only operates CW and maybe SSB is less proficient than a
5 WPM Technician that operates on 10 different digital modes. See the
10 modes is more than CW and SSB, that ham is more proficient. Then I
guess I agree with you.

Your comments on setting up networks, sat communication, and digital
modes show that you have little knowledge on either. For instance, it
depends on the sat orbit how long it is useful.

If PSK cannot be used due to ionospheric disturbances, well then either
can CW. Computers can be operated on battery or generator. You are
going to need something to power the radio right? Does not take much
more for a laptop and with digital modes, the power can be much less so
there is more power for the laptop.

Your comparison of voice, digital modes and CW shows you have little
knowledge of what you are talking about. I have personally used digital
modes when voice and CW were not able to be copied.

Finally, I happen to like CW a lot. But I don't think it makes anyone a
better operator for knowing it, you should not be tested on it anymore
than any other mode. Yes, there are a lot of seniors using digital, but
there are too many more hanging on to the old crap CW only and tubes.



Dee Flint wrote:


If they are proficient in code as well as other modes, then they are a more
proficient operator. The more you can do, the more proficient you are.


Setting up digital networks may not be particularly practical in the early
days right after a large scale disaster. Satellite passes are short and if
you don't have internet access to look up pass times, you may be up the
proverbial creek without the proverbial paddle if you rely too much on that
form of communications. Even with the pass info, the passes are too short
to be useful for handling very much emergency communication.


Yes it is true that PSK31 can be copied when you cannot hear it. However,
it is useless when there are ionospheric disturbances that cause phase
shifts (solar flares with the attendent aurora come to mind). This happens
on a fairly regular basis. In addition, although the signal you are putting
out is low power, PSK31 has a fairly high power consumption requirement
since a computer is essential in the system. If you have limited power
resources, it may not be a wise choice.

While code is not the end-all and be-all, it still has its place in list of
communications methods. Let us go back to the auroral activity. The
various digital modes fail first. Voice holds up a little bit longer
getting distorted but sometimes still copyable. Code holds up a bit longer,
being still copyable when voice becomes too distorted. Under auroral
conditions, both voice and code fare better than digital.

Every single method has a valid place in the list of communications methods.
Every mode has its strong points and its weak points. In my opinion, hams
should be able to use as many modes as possible and that includes code.

The major drawback to code is that it requires people to develop a skill
rather than being a matter of just slapping parts together. Heck, I don't
any skill in soldering as I've soldered only about 4 items in my life but I
built both myself and my OM PSK31 interfaces in about 1/2 hour each. They
were two of those four items.


I find that it is the "old farts" who are doing most of the exotic
activities. When I work PSK31, I come across many seniors working this mode
with the latest radios and computers. When I work VHF/UHF contests and look
up the call signs afterwards, it is mostly the experience hams that I run
across.

You have let your disdain for the code blind you to its merits. As I stated
above, EVERY mode has its strengths and weaknesses and its place in wireless
communications.

Dee, N8UZE