proper antenna installation
 

Hi all,

I have two omni dipoles @ 2.4Ghz, one positioned for vertical
polarization and the other horizontal. I have stiff coax feeding these
two antennas. The horizontal antenna is above the vertical, and the
coax feeding the horizontal runs pararellel with the vertical antenna
around 2 wavelenghts (24cm) away. My question is will the signal on
the coax leak onto the vertical antenna? I want the two to be as
orthogonal as possible. I'm not really sure on the physics involved
but is there a standard seperation that is required to minimize this
effect or will they always be coupled if I run the lines in this
manner? Thanks for any info,

Kev

proper antenna installation
 

wrote in message
ups.com...
Hi all,

I have two omni dipoles @ 2.4Ghz, one positioned for vertical
polarization and the other horizontal. I have stiff coax feeding these
two antennas. The horizontal antenna is above the vertical, and the
coax feeding the horizontal runs pararellel with the vertical antenna
around 2 wavelenghts (24cm) away. My question is will the signal on
the coax leak onto the vertical antenna? I want the two to be as
orthogonal as possible. I'm not really sure on the physics involved
but is there a standard seperation that is required to minimize this
effect or will they always be coupled if I run the lines in this
manner? Thanks for any info,

Kev


Hi Kev

I notice that you arent getting an answer from the guys on this News Group
who actually know how to properly solve the problems you are concerned with.
Are you concerned about inducing RF into one coax because of its being 2
wavelengths away from a radiator parallel to it? If so, I can assure you
that the isolation from the vertical antenna to the inside of the paralled
coax will be Very high. I'd expect *that* kind of coupling to be so low
that it would be difficult to evaluate it.

The antennas will be "orthoganal" because they are physically mounted that
way.

Jerry

proper antenna installation