Hi guys,
I would like to use a (not so) random wire antenna to transmit on HF
band.
What is the power (watt) that I can use on my rig to feed the antenna?
Of course after tuning it.
I can use it full power (100W) or no?
For 100W which kind o wire is good?


Thanks.

Andrea
IZ2LSC

On Thu, 07 Jun 2007 14:36:23 -0000, Andrea wrote:

Hi guys,
I would like to use a (not so) random wire antenna to transmit on HF
band.
What is the power (watt) that I can use on my rig to feed the antenna?
Of course after tuning it.
I can use it full power (100W) or no?
For 100W which kind o wire is good?

Hi Andrea,

100W will work just fine. Use copper wire with a diameter of 1mm or
more.

73's
Richard Clark, KB7QHC

Thanks Richard.
Do you know if there is a formula to calculare the max power that a
wire can supports?

Thanks.

Andrea
IZ2LSC

Andrea wrote:
Thanks Richard.
Do you know if there is a formula to calculare the max power that a
wire can supports?

Thanks.

Andrea
IZ2LSC


Max power that the wire can support would be based solely on the
amperage it can carry. You would need to know what the amps are at a
current node ... but, I have run a KW+ on #12.

Currently, I use 1/4 inch copper tubing over steel fencing wire (steel
wire is for strength.) It has supported 5KW+ easily ...

JS

On Thu, 07 Jun 2007 13:11:38 -0700, Andrea wrote:

Thanks Richard.
Do you know if there is a formula to calculare the max power that a
wire can supports?

Hi Andrea,

No. Not off-hand. I use "wire tables" to reference what is called
"fuse current." This is the current that will burn a wire open. For
a 1mm wire, that would be around 50 to 80 Amperes. Your antenna would
have to be a very small loop to encounter that kind of current. Very
small means less than 0.1 wavelength in diameter. You would encounter
other problems long before the wire would melt.

73's
Richard Clark, KB7QHC

Richard Clark wrote in
:

On Thu, 07 Jun 2007 13:11:38 -0700, Andrea wrote:

Thanks Richard.
Do you know if there is a formula to calculare the max power that a
wire can supports?

Hi Andrea,

No. Not off-hand. I use "wire tables" to reference what is called
"fuse current." This is the current that will burn a wire open. For

Are those tables based on the DC resistance or low frequency AC resistance
of the wire?

If so, are they relevant to rating the wire for current handling capacity
at RF where for example skin effect increases the dissipation for a given
current?

Owen

On Fri, 08 Jun 2007 06:27:13 GMT, Owen Duffy wrote:

If so, are they relevant to rating the wire for current handling capacity
at RF where for example skin effect increases the dissipation for a given
current?

Hi Owen,

Really, a 1mm wire is sufficient for a 100W transmitter in a long wire
antenna application. There is no need to elaborate.

73's
Richard Clark, KB7QHC