Home |
Search |
Today's Posts |
#22
|
|||
|
|||
measuring cable loss
On Mon, 13 Aug 2007 13:09:09 -0700, Jim Lux
wrote: Or, something like a 50k resistor into a 50 ohm load will be about 60 dB down, Hi Jim, Unlikely. With parasitic capacitance at a meager 1pF across the 50K, its Z at 10MHz would compromise the attenuation presenting closer to 50 dB down. At 1Ghz it would plunge like a rock. This, of course, presumes a 1/4 watt resistor. A better solution is to use surface mount resistors where the parasitics are down at 100aF - but then you will have a frequency dependant divider unless you can guarantee that the parasitic capacitance of the 50 Ohm resistor is 100pF (sort of casts us back into using a 1/4 watt resistor with a padding cap). At 1GHz, it is not going to look like a trivial 50K load anymore. A Pi attenuator will do it better. 73's Richard Clark, KB7QHC |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Measuring quarter wave cable length with HP 8405A | Antenna | |||
Calculating Coaxial Cable Loss | Antenna | |||
Antenna cable loss query | Scanner | |||
Antenna cable loss query | Shortwave | |||
Measuring small inductances using a return loss bridge | Homebrew |