| Home |
| Search |
| Today's Posts |
|
#11
March 4th 08, 03:22 AM
posted to rec.radio.amateur.antenna
|
|||
|
|||
2 x 4 to 1 voltage balun in series
In article ,
says... Hi can someone explain how to connect 2 voltage 4:1 baluns in series to achieve 16:1 Thanks Bit of update finished the antenna and got it up and running yesterday, the only HF gear I have ATM is a 27MHz SSB Cb radio (12 watt), got 1.5-1.6/SWR, so I guess is working ?:-) (lot of thanks for those who helped) I was lucky to find 2mm(SQ) tinned wire Insulated, I made the resistor out of 20 x 18k CF 1w resistor soldered in parallel. my next question is how much power this antenna can or should handle? I was thinking somewhere around 20 watts ? -- The information contained in this post is copyright of the poster, and specifically may not be published in, or used by http://www.jlaforums.com |
|
#12
March 4th 08, 05:39 AM
posted to rec.radio.amateur.antenna
|
|||
|
|||
|
2 x 4 to 1 voltage balun in series
Cheers wrote:
I have a bunch of 600 ohm 50 watt non-inductive resistors. My email address is Sent you an email to the above address few days ago, have you received it? Sorry, no, I didn't get it. It must have gone into the junk folder which gets automatically deleted. Please send it again and I'll look for it. -- 73, Cecil http://www.w5dxp.com |
| Reply |
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| FA.Voltage Tap Switch for AR.88/CR.88 series Receivers | Boatanchors | |||
| Voltage vs. Current Balun - OCF Dipole | Antenna | |||
| Voltage BalUn Frequency Range | Antenna | |||
| is voltage balun right choice? | Antenna | |||
| Horizontal loop - balun or no balun ? | Antenna | |||
Linear Mode
