Home |
Search |
Today's Posts |
#6
|
|||
|
|||
Ladder Line Entry to Shack
K8JRM wrote:
Hi Guys, This is an age old question - what is the best way to get 450 Ohm ladder line into my shack antenna tuning unit (ATU)? Here is my situation; I have two 4" PVC tubes inserted into the exterior wall that allow the entrance of coaxial cable into my shack. When I run the ladder line into the shack through one of these ports, the multi-band wire antenna fed with the ladder line goes wild! I can not get the antenna to tune with any of my ATUs. I have received several suggestions on how I can overcome this problem. The most promising one seems to be to use two short pieces of coax with center conductor connected to either side of the ladder line. These pieces of coax, in turn, would be fed through the PVC hole into the shack and the center conductors connected to the ATU. The shield on the coax would float with no connection to any thing. This solution sounds good; however, common sense tells me that ladder feed line will still suffer because of its proximity to other objects. Any thoughts on this solution? Another possibility is using a piece of Plexiglas place under a metal framed window pretty much as shown in the old hand books. My problem with this solution is that the window is on the other side of the room from operating table, the two coax entry ports and AC power. Short of placing the tuner outside in the elements, is there a solution to my problem? I would be interested in hear what has been tried! Tom, K8JRM in OKC Tom, Sounds like your running the ladder line with some other conductors in the PVC. You never said how far the entry point was to the ATU, if its relatively short less than 15' or so I would recommend you run a piece of coax from the ATU through the PVC to a 1:1 balum located outside. there would be some loss in the coax/balum but it would be low on 160-30M and some what higher on 20-10 meters. I don not think you can quantify the amount of loss but I don't think you will see it via RST reports. I have successfully used this method over several years since I did not have the 4" PVC that you luckily have for the coax and other conductors. The above suggestion is made on the assumption that the ATU has a unbalanced output for coax and is not a balanced only tuner. With respect to the addition of two (2) pieces of coax as a feed through on the inside of the home the shields are connected together and then joined to the ground system in the shack. From the feed through point then you can continue with the ladder line to the ATU. I recommend the remote balum since it helps cut down on any coupling of RF to other conductors in the PVC. Use a good current type balum since the swr is likely to vary over the multiple band use. The length of ladder line from the balum to the feed point of the antenna is some what critical and there is lots of articles on the subject on the WEB, I believe DX Engineering has some excellent white papers on this subject for remote balums. 73 de Ron W4LDE |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
ladder line?? | Antenna | |||
Using Twin Lead or Ladder Line for your Antenna's Feed-in-Line ? - Then 'consider' a Pair of Vintage Style TV Antenna Clips . . . | Shortwave | |||
Feed Line Length - Ladder Line | Antenna | |||
Source For 72 or 75 Ohm Ladder Line ??? | Antenna |