Home |
Search |
Today's Posts |
#10
![]() |
|||
|
|||
![]() "David" nospam@nospam wrote in message ... Which antenna is better: 5/8 wavelength vertical or a J pole? Frequency of operation is 145 MHz = 2 metres. The 5/8 wavelength vertical has a loading coil. There are losses in the coil. The J pole has a quarterwave matching stub. The matching stub provides an out of phase current which means that there is a cancelling field close to the radiating element. Also the J pole is end fed, which means the transmitter is not connected directly to a maximum current point. Does the J pole have a disadvantage because of the cancelling field from the matching stub and the fact that it is end fed? Also consider gain and angle of radiation. I'm currently building a 5/8 wave ground plan for 2mx as a tower based antenna, I have used J pole and slim jim type antennas in the past for the same purpose with success. I would think that the 5/8 radiator may have slight gain advantage, but believe that the J pole may have a slightly lower angle of radiation. The J pole is certainly easier to construct as there is a bit of mucking about with 1/8wave loading coil on the 5/8 antenna. There has been much discussion about common mode currents produced on the feed line for the J pole that can create an unpredictable radiation pattern which is partly why I'm constructing the 5/8 and partly I'm building a 5/8 ground plan as I have never built one before. Build both and compare. If the antenna is for mobile I would certainly use the 5/8 antenna. -- Peter VK6YSF http://members.optushome.com.au/vk6ysf/vk6ysf/main.htm |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
j-pole 5/8 wave | Antenna | |||
1/2 wave vertical Impedance ??? | Antenna | |||
5/8 wave 6m vertical | Antenna | |||
1/4 wave vertical vs. loaded vertical | Antenna | |||
vertical di pole | Shortwave |