On Tuesday, 21 June 2011 18:20:25 UTC+10, Helmut Wabnig wrote:
What influence has a metallic boom on a Yagi antenna?
Normally the design is made without taking the boom into
consideration.

No necessarily, but it is common to design for a non-conductive boom and then make a correction to element lengths for the type of boom in use.

http://yfrog.com/janextgen14p

The voltage curves on the parasitic elements have their maximum
in the center. When using a non-conductive beam the situation is not
affected.

That is not true.

With a metallic boom and with the parasitic elements fastened
to the metal would the oscillation pattern be changed?

Depending on how the boom is or is not bonded to the element, and the geometry (sizes, position etc), the conductive boom may reduce the magnetic flux nearest to the element, effectively reducing its inductance in the middle area, so tuning it higher.

Do I have to insulate the parasitic elements from the metallic boom
or is it advisable and allowed to fix them with metal fasteners?
Does the connection have to be made electrically good,
or does it not matter at all?

If the 'connection' has infinite R (ie no connection) or zero R, there is no power converted to heat, otherwise you invite conversion of RF energy to heat.


In fact there are both designs used, but probably without further
consideration. Some manufacturers use plastic holding clamps

Not by competent designers, they consider the effects of the boom.

for mounting the elements, for no other reason than saving time
during assembly. Other manufacturers just drive a self cutting
thread screw through everything.

The YAGICAD software does talk about mounting elements
on the boom, and NEC is too difficult for me to understand.

Thank you in advance for your answers, and a sixpack
will be kept ready to compensate your efforts at your next visit.


The foregoing may challenge your thinking on the subject.

Owen