Why do balun builders always use "enameled" wire?
 

Why do balun builders always use "enameled" wire? Won't regular
electrical insulated copper wire like they sell at Lowes or Home Depot
work? Since copper is copper what is the benefit of enameled wire
over other types of insulated wire? Also is there a benefit of using
solid copper wire over stranded copper wire to build a balun?

Michael Rawls
KS4HY

Why do balun builders always use "enameled" wire?
 

On 7/5/2011 7:15 AM, Michael wrote:


Why do balun builders always use "enameled" wire? Won't regular
electrical insulated copper wire like they sell at Lowes or Home Depot
work? Since copper is copper what is the benefit of enameled wire
over other types of insulated wire? Also is there a benefit of using
solid copper wire over stranded copper wire to build a balun?

Michael Rawls
KS4HY

Because the windings on a balun is not just turns on a core. They are
transmission lines of a specific impedance. Wires of a diameter must be
a certain distance apart to make a line of of the desired impedance. If
the line is supposed to be 50 Ohms they need to be close together, too
close for the thick insulation on house wire. Stranded wire is harder to
wind on a ferrite core and maintain the spacing that is needed to make a
good balun. Just remember that baluns are not transformers in the
classic meaning of the term. They are made of sections of transmission
lines. For example a 4 to one balun is made of 2 100 Ohm lines that are
connected in parallel on one end, 50 Ohms side and in series on the
other end for the 200 Ohm side. The common mode impedance keeps one end
from seeing the other at RF frequencies. You can not see this with a Ohm
meter!

John W3JXP

Why do balun builders always use "enameled" wire?
 

Michael wrote in news:b0e34c58-9da5-4520-8433-
:



Why do balun builders always use "enameled" wire? Won't regular
electrical insulated copper wire like they sell at Lowes or Home Depot
work? Since copper is copper what is the benefit of enameled wire
over other types of insulated wire? Also is there a benefit of using
solid copper wire over stranded copper wire to build a balun?

The don't ALWAYS use enamelled wire, but yest, it is very common.

I previously reocmmended a 1:1 current balun to you, so I will answer
your question in that context. (I do note though that someone has since
recommended a voltage balun.)

If you are looking for a 'general purpose' balun to use with an ATU, you
should be more interested in a balun that can withstand high voltages
than close to ideal impedance transformation.

ECW is a relatively poor choice, and Thermaleze ECW which has a higher
nominal voltage rating seems not up to the task at extreme loads. PTFE
sleeved ECW or PTFE insulated flexible wires seem a better option for
extreme loads.

Stranded wire does have higher loss than an equivalent circular
conductor... but losses in a current balun in a practical antenna system
are usually mostly due to common mode current causing heating of the
core, ohmic losses in the windings are usually much lower and
insigificant... though they do commonly feature in published
specifications.

Again, more info is available if you want the links.

Owen