On Mon, 26 Mar 2012 20:22:09 -0400, " Tuuk"
wrote:

Anyone familiar with the Energiser CHDC-CA Battery Charger?

Yep. I have one. Piece of junk. Works only with NiMH. It will kill
a NiCd battery and will overcharge a partly charged battery.
http://data.energizer.com/PDFs/chdc.pdf
"Best used with Energizer NiMH batteries."
Note that it's obsolete.

Now, my new batteries ni mh are 3000 mah.

Maybe, under ideal conditions and with a very small load. Otherwise,
I've never seen a 3000ma-hr battery.

I have a West Mtn Radio CBA-II battery analyzer:
http://www.westmountainradio.com/product_info.php?products_id=cba3&navcode=/cbaLink1
I've tested a few of the flea market NiMH batteries claiming to be
3000ma-hr and found them lacking. I'll post the graphs (if I can find
them).

Incidentally, did you know that it requires one or two initial charge
cycles to get an NiMH battery up to full capacity? I didn't believe
it so I ran some tests:
http://802.11junk.com/jeffl/NiMH/
It's not much, but it's certainly real. Note that the load was on the
high side at 1C resulting in measured battery capacity lower than
claimed. This is normal, but I was in a hurry.

Anyone have experience with these? Just typical rechargable batteries for
camera. Any tips on charging these properly?

If it's only run by a timer, it's a piece of junk. It probably
assumes that the batteries to be charged are totally discharged, and
after 8.5 hrs of charging, will be fully charged. That sucks because
a half charged battery will be overcharged by that method. If the
batteries get warm, they're being overcharged.

What it should do is look for a decrease in terminal voltage,
indicating EOC (end of charge).
http://en.wikipedia.org/wiki/Nickel%E2%80%93metal_hydride_battery#.CE.94V_charg ing_method

Mo
http://batteryuniversity.com/learn/article/charging_nickel_metal_hydride

Now, can be get back to antennas?

--
# Jeff Liebermann 150 Felker St #D Santa Cruz CA 95060
# 831-336-2558
# http://802.11junk.com
# http://www.LearnByDestroying.com AE6KS