k40
 

On Mon, 13 Jul 2015 07:28:28 +0100, Jeff wrote:

cutting or stretching the whip. If you cut it, it DECREASES the
operating frequency.

That should be INCREASES.
Jeff

Oops.

--
Jeff Liebermann
150 Felker St #D http://www.LearnByDestroying.com
Santa Cruz CA 95060 http://802.11junk.com
Skype: JeffLiebermann AE6KS 831-336-2558

k40
 

cutting or stretching the whip. If you cut it, it DECREASES the
operating frequency.

that is what I thought but I have cut it and cut it and I can't get it doewn
to 21 Mc/s ...

k40
 

Jeff Liebermann wrote:
On Sun, 12 Jul 2015 09:58:00 +0100, "Cottaging by the sea ..."
wrote:

going by adverts the k40 must be the best antenna on the market....can I cut
it for 15m ????

The K40 is a CB antenna made for 27 MHz. 15 meters is 21 MHz and is
therefore lower in frequency than what the K40 is tuned. You would
need to lengthen, not "cut" the antenna in order to lower the
frequency.



It is a troll.

k40
 

On 7/12/2015 4:41 PM, Ralph Mowery wrote:
"rickman" wrote in message
...
.

I don't get it. I've cut this antenna three times and the frequency is
*still* too high.

The more you cut, the higher the antenna operating frequency.

I guess I should have put a smiley at the end of that. When I worked
construction the guys would kid saying, "I've cut this board off three
times and it's still too short!"


Reminds me of the time I had carpet put in and needed to cut down a door so
it would close. I cut it twice and it was still too long and rubbed the
carpet. Looked at the top and there was almost an inch gap. Good thing it
was just a closet door.

lol, good one

--

Rick