Question about LMR-200 and N connectors
 

I'm putting up a discone for UHF/VHF and have settled on LMR-200 as a good
performance/size compromise cable. I have some W5SWL crimp on N conectors
for this cable. I'm wondering what dimension the crimping tool die should be
for crimping on the center pin. I thought it was suppposed to be 0.100
inch, but that's too big. Anyone know the correct crimp dimension?
--
Lee K. Gleason N5ZMR
Control-G Consultants
lee.gleason@comcastnet


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus

Question about LMR-200 and N connectors
 

On Friday, October 21, 2016 at 6:18:41 PM UTC-4, Lee Gleason wrote:
I'm putting up a discone for UHF/VHF and have settled on LMR-200 as a good
performance/size compromise cable. I have some W5SWL crimp on N conectors
for this cable. I'm wondering what dimension the crimping tool die should be
for crimping on the center pin. I thought it was suppposed to be 0.100
inch, but that's too big. Anyone know the correct crimp dimension?
--
Lee K. Gleason N5ZMR
Control-G Consultants
lee.gleason@comcastnet


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus

Why not solder it?