Ken Smith wrote:
RF transmitter power amps are certainly "impedance matched" to the
intended load. Take a look in the ARRL "The radio amateur's handbook".
If you have the 1944 addition, you will need to start reading at page 96
in the lower right column. If you don't have that, try Motorola's AN-721.

A CMOS Class-E amp is in full saturation (0.5v at 2a)
for 10% of a cycle and off (12v at 0a) for the other
90% of a cycle. The tank circuit changes the digital
energy to analog energy by filtering out everything
except the fundamental frequency component. How
in the world does one determine the steady-state
impedance of the CMOS source? Isn't the best one
can do with a digital switch is to keep it within
specified parameters? The CMOS device dissipates 2
watts for 10% of the time - therefore 0.2 watts
steady-state.
--
73, Cecil http://www.qsl.net/w5dxp


----== Posted via Newsfeeds.Com - Unlimited-Uncensored-Secure Usenet News==----
http://www.newsfeeds.com The #1 Newsgroup Service in the World! 100,000 Newsgroups
---= East/West-Coast Server Farms - Total Privacy via Encryption =---