| Home |
| Search |
| Today's Posts |
|
#6
|
|||
|
|||
|
Bob Schreibmaier wrote:
Hi Tom, In article , you say... I haven't asked anything impossible or even tough, since I only gave a general bound on size, gave the rough band limits desired, and said we'd like gain and directivity. Well... :-) On a band that has a bandwidth of roughly 4% of its center frequency, you're going to be REALLY hard-pressed to get coverage of both phone and CW on an antenna that is a little over 40% of full size. So far, no manufacturer has been able to come up with the antenna you describe. Many years ago, Swan Antennas had a 2-element 40 meter beam that used half size elements. As I recall, it used loading coils midway through each element. I'm not very sure, but I think the boom length was about 16 feet. I think they got somewhere around 100 kHz between 2:1 points. That wouldn't even cover the entire phone band, and the elements are longer than your design requirements. So, yes, you are asking for something very tough, if not impossible. But, I wish you good luck in your quest! :-) 73, Bob And also from my original post "o Boomlength 30 feet o Element length 30 feet " which is a whole lot more than 16 feet. But you are probably correct. It's impossible. |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Inverted ground plane antenna: compared with normal GP and low dipole. | Antenna | |||
| Discone antenna plans | Antenna | |||
| QST Article: An Easy to Build, Dual-Band Collinear Antenna | Antenna | |||
| Ten-tec vee beam | Antenna | |||
| Compact HF antenna (RX-only) for reference in antenna tests? | Antenna | |||