On 30 Mar 2005 08:08:27 -0800, "Brian Kelly" wrote:

2. Remove half the transmission line muffling of results by using a
field strength meter to find resonance (another reason for power);

Same as above but with a field strength indicator? Just might work if I
use a 4-digit DVM and a diode.

Excellant choice (add a filter cap too with resistive load for
averaging).

3. Find the Vf (as you put it) by derivation against a wire model
(through the difference in lengths of bare wire model resonance to
real wire resonance);

That would seem to work but I'd expect to still have the flat curves
because of the coax losses.

Hi Brian,

Actually, by using the FSM you entirely remove the transmission line
as disturbance to accurate response readings. Those come from the
external reading which interprets all power being applied AT the
antenna junction. However, it imposes upon you that you be scrupulous
about achieving the same drive levels at all the intermediate
frequencies across the swept band. If you do that, then the
transmission line characteristics for the drive going up to the
antenna junction fall out too.

Careful drive monitoring, and careful response monitoring render the
transmission line transparent to the measurement. Thus response/drive
is the antenna characteristic. Define one point's SWR, and you can
cast that into the suite of readings for a swept SWR curve. Take care
in that "one" SWR determination to anticipate the SWR lowering effect
of transmission line loss.

Then you do the same thing in software, and tailor the characteristic
insulation thickness to match your measurements. Having achieved
that, then you have your standard insulation. This does not give you
Vf until you then remove that virtual insulation and find the native,
bare wire resonance. This last step is satisfying (it answers your
question as to Vf), but the step before is more useful because you can
model other antennas from that standard.

73's
Richard Clark, KB7QHC