OK....I think I uderstand the transmitter side, perhaps a little better. If
a 50 ohm transmitter is matched to a 50 ohm antenna there is no reflection
and all the power is radiated. If the antenna is not 50 ohms then there is
reflected power from the antenna to the transmitter and since the
transmitter cannot absorb power it reflects it to the antenna ad infinitum.
I also know that electric power generating station don't like a match
because a 50/50 deal is not good for profits. I understand the transmitter
and power generator however I'm having trouble getting my mind around whats
happening with the receiver and antenna. Can it be put another way so I can
try to understand it?
tnx

--

73
Hank WD5JFR
"Richard Harrison" wrote in message
...
Henty Kolesnik wrote:
"How about a little more explanation on the 50% reradiation?"

The antenna doesn`t care where the power comes from. It can be from
connected drive or induced. Induced power has two loads, radiation
resistance and connected load (receiver input). If they are matched
(equal), 50% is absorbed in each.

If they are mismatched, paximum power transfer can`t occur. A higher
percentage of the available energy will be rejected or reradiated
because the receiver input is nearer to an open circuit (rejection) or a
short circuit (reradiation) than it is when it is matched to the
antenna`s radiation resistance.

Best regards, Richard Harrison, KBWZI