Home |
Search |
Today's Posts |
#21
![]() |
|||
|
|||
![]()
Lightning attaching to a wire will instantly vaporize the wire.
Not always. Depends on the resistance of the ground connection. If the resistance is low, a # 6 wire can take a direct strike, and barely warm up at all. Even a #10 is ok, if the connection to ground is good. You might see a tiny pit where the point of contact was. But a high resistance ground connection, and yes, it will fry. I've taken two direct strikes on my mast, and can see no damage at all. You can see a tiny pit where the strike connected to the mast top, but even it could be easily missed. According to my experience, I think the quality of the ground connection also effects the sound of the strike, not counting the sonic boom overhead. A strike hitting my mast is very quiet. It's like a light bulb being thrown on the ground, "plink", and you hear the overhead sonic boom. But when it hits the trees with their high resistance to ground, the strike is earsplitting. "CRACK-BAAAAAMMMM". ![]() I don't operate during storms, and doubt I would, even if I could. I unplug the antennas, and ground them out to ground outside the window. If I *had* to operate during a storm, I would use my attic dipole. It's the least likely to take a hit, in general. MK |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Lightning Protection - What Do YOU Use? | Shortwave | |||
FYI: NOAA Lightning Safety Awareness Week | Policy | |||
Antenna Suggestions and Lightning Protection | Shortwave | |||
lightning protection | Shortwave | |||
Lightning Protection | Antenna |