Home |
Search |
Today's Posts |
#1
![]() |
|||
|
|||
![]() Some years back I buried a 30 metre (60-feet) auminium wire one spade depth in my back garden. Wire was 1.5 mm in diameter. Soil resistivity about 100 ohm-metres. To scientists that's 10 milli-Siemens. The near end of the wire came up in the shack. That's under my kitchen sink. It's still there. Open-circuit at the far end. As a counterpoise, something essential to tune it against, I erected a wire in the form of an inverted-L. This was about 30 feet high and overall length about 140 feet. I chose this length because it fitted nicely into my back garden. The front garden is too short even for an underground antenna. On the 160m band I fed into it about 30 watts from a home-brew transceiver so I can't provide for the record a manufacturer's type and serial number. However I still have the transceiver which can be inspected. Despite a high local noise level of S-6 I was able to communicate up to 60 miles with mobile stations in broad daylight on SSB. After sunset I could easily communicate with most of Europe on CW. I think a record of these buried antenna experiments should be kept for posterity, alongside the famous biblical work of B,L & E. By the way, as you see, I did remember to measure soil resistivity. It was the first thing I did. What buried wire do you think I used to measure it? ---- Reg, G4FGQ |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Inverted ground plane antenna: compared with normal GP and low dipole. | Antenna | |||
Air Force One coax ?? | Antenna | |||
The "TRICK" to TV 'type' Coax Cable [Shielded] SWL Loop Antennas {RHF} | Antenna | |||
Handy Shortwave Chart | Shortwave | |||
QST Article: An Easy to Build, Dual-Band Collinear Antenna | Antenna |