Home |
Search |
Today's Posts |
#14
![]() |
|||
|
|||
![]()
Tam/WB2TT wrote:
I am happy with mine. Only thing I can add is that it eats batteries, and my unit does not like to work below 13 Volts. They do sell a tunable bandpass filter for the lower frequencies. I tried a high pass filter - don't bother, it messes up the phase. If you do want to measure antenna impedance with something like the MFJ and have trouble (as I do) with local broadcasting and other RF, I recommend using a "half wave" filter. This type of filter has reasonable out-of-band attenuation characteristics and doesn't disturb the impedance measurement too much. (Over a limited frequency range it mimics a half wavelength of transmission line.) The impedance disturbance will be the least when the filter is designed to approximately match the measured impedance. It's simply two cascaded pi sections, with each element having the same value of X. For example, a lowpass looks like this: ---.---L---.---L---.--- | | | C 2C C | | | ----.-------.-------.--- For example, a filter with Z0 = 50 ohms (one which mimics a half wavelength of 50 ohm line) has XL = XC = 50. One designed for 7 MHz would have L = 1.14 uH, C = 455 pF. You can wind the coils on small type 2 or 6 powdered iron cores, and use the closest standard value (e.g., 470 pF) for the capacitors. This filter will cause little impedance disturbance at 7 MHz and, for load impedances near 50 ohms, at lower frequencies also. A highpass looks like this: ---.---C---.---C---.--- | | | L L/2 L | | | ----.-------.-------.--- Again, XL = XC = the filter Z0. Make filters according to your particular measurement needs. You can check the amount of disturbance the filter causes by making a known impedance out of a resistor and capacitor or inductor which is about equal to the measured impedance, and measuring it with and without the filter. If you can read German, there's a marvelous book describing how to make a wide variety of measurements with an antenna analyzer, with tricks, tips, and details. It's _HF-Messungen mit einem aktiven Stehwellen-Meßgerät_ by Gerd Janzen, DF6SJ. It's available directly from him at Hochvogelstraße 29, D-87435 Kempten, Germany. Roy Lewallen, W7EL |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Spectrum Analyzer vs. Field Strength Analyzer | Homebrew | |||
practrical spectrum analyzer | Policy |