This is a series of questions about AM broadcast antenna and lead-in
problems I have, it is not a strictly "amateur radio" question, so I hope
you forgive the intrusion but I thought this group to be the best for the
question.
I have purchased a Russound ST2 dual tuner for medium wave (AM broadcast)
and FM for my whole house audio system. I have hooked up a Radio Shack FM
Stereo Antenna in the attic and it works well for FM. The AM antenna input
is 300 ohm. Two loop antennas (about 5" diameter) are supplied but do not
work well in the room I have the tuner as there is lots of noise and weak
signal. I would like to mount the supplied loop antenna(s) in the attic. I
am 18 miles from New York and only want to recieve local broadcasts (no DX).
It is not practical for me to put up a 200 foot longwire. I have to make
some decisions:
1. Can one antenna feed both tuners by being hooked up in parallell? Is
there a signal loss?
2. Am I better off using 300 ohm flat TV type cable or should I use two
300/75 transformers (one at the reciever and one at the loop antenna) with
RG-6 quad shield? I am wondering if the transformer loss is worth the
possible noise reduction from the coax.
3. Should I be able to use 1 loop for the two tuners and the coax, is it
best to split the 75 ohm coax and use independent 300 ohm transformers or to
split the 300 ohm feed from one tuner to the other?
4. Is it possible to use the FM antenna for the AM and how would it be best
to split that up? (I would have to feed two FM and two AM tuners but only
two could be used at once).

Thanks,
Eric