paint antenna? Aluminum paint?
 

On Sun, 16 Apr 2006 21:48:26 -0700, Roy Lewallen
wrote:

Buck wrote:
I have seen my father use aluminum paint from way back in the 60's. I
haven't seen it lately, not that I have looked, but I wonder how it
would work.....

As a guess, very badly. The aluminum in the paint is in the form of
small particles, each probably covered with an oxide coating. So the
conductivity would be very poor, even if the paint dried in such a way
as to bring the individual particles into contact with each other (which
it very well might not).

Roy Lewallen, W7EL


I figured there must be some problem with it's conductivity if someone
just invented paint to be conductive, but I hadn't tried it.

Thanks


--
73 for now
Buck
N4PGW

paint antenna? Aluminum paint?
 

A bit pricy,

But it can be done:
http://www.lessemf.com/paint.html

73 John (PH9Z)

paint antenna?
 

ml wrote:

just read a article someplace about a new conductive paint that is going
to be used by different sources (pvt/mil) to in effect paint an antenna
on a surface. once such use was an 'orbiting' blimp , planes etc to
repete signals


ok so i wonder my roof has a flat brick wall it's 40ft tall 40ft wide

if i painted a antenna design think i'd get any useful performance in at
least one direction?

unf it didn't state any spec's but it's commercial


just really thinking out louad how a antenna w/little profile but
otherwise large surfacce area might work


The metal powder paints are not working well as antennas, copper or
aluminium makes no difference. To be able to paint an antenna on an
isolating material, I use the silver oxide based paints. Some of these
paints can even be soldered on. You can connect the coax by capacitive or
direct connection, just make up a small pcb with the gilded side towards
the painted surface and it'll work fine. Just glue it to the surface.

You often find this type of paint for repairs of windscreen heater coils.

The normal variants are transparent and a slightly greenish-silverish
colour.

You can paint an antenna on a car window if you have a standard glass and
none of the new gilded glass with a surface heater or defroster.

However, as the paint is not resistant to wear, like cleaning a window, you
have to cover the painted areas with a self adhesive film.

The painted antenna was tested for use in buses and subsequently for VHF and
UHF only.
Output power in tens of watts are ok but I did not test with higher powers.

You can also make a precut fractal template and just apply the paint with a
roller or a cloth....


Cheers

Dan / M0DFI