RadioBanter

RadioBanter (https://www.radiobanter.com/)
-   Boatanchors (https://www.radiobanter.com/boatanchors/)
-   -   A question on tube rigs in general, Kenwood in particular (https://www.radiobanter.com/boatanchors/118115-question-tube-rigs-general-kenwood-particular.html)

Chuck Harris April 16th 07 02:38 AM

A question on tube rigs in general, Kenwood in particular
 
Clif Holland wrote:
All I can say is if you follow those directions, Good Luck.



Very well, please explain the correct method.

-Chuck

Fred McKenzie April 17th 07 06:17 PM

A question on tube rigs in general, Kenwood in particular
 
In article om,
"billcalley" wrote:

2. Find the single trimmer capacitor located near the 500Hz CW filter
(the trimmer capacitor will be able to shift the 500Hz CW filter
center frequency by some small amount).


Bill-

You may be able to accomplish your goal without a counter, but the
trimmer you need to adjust is one of a group of three next to three
crystals on the carrier unit. It is probably not on the filter board
unless the two boards are combined in the TS-530.

I don't know for sure if the TS-520 manual is applicable. Although it
shows the crystals and trimmers in a photo and on the circuit diagram, I
couldn't find a procedure for their adjustment. It would help if you
could find a copy of the TS-530 service manual.

Fred
K4DII

Clif Holland April 17th 07 07:25 PM

A question on tube rigs in general, Kenwood in particular
 
The 520 and 530 are about as close as an elephant and a donkey.... About the
only thing they have in common is tubes finals and the brand.

--

Clif Holland KA5IPF
www.avvid.com




"Fred McKenzie" wrote in message
...
In article om,
"billcalley" wrote:

2. Find the single trimmer capacitor located near the 500Hz CW filter
(the trimmer capacitor will be able to shift the 500Hz CW filter
center frequency by some small amount).


Bill-

You may be able to accomplish your goal without a counter, but the
trimmer you need to adjust is one of a group of three next to three
crystals on the carrier unit. It is probably not on the filter board
unless the two boards are combined in the TS-530.

I don't know for sure if the TS-520 manual is applicable. Although it
shows the crystals and trimmers in a photo and on the circuit diagram, I
couldn't find a procedure for their adjustment. It would help if you
could find a copy of the TS-530 service manual.

Fred
K4DII





All times are GMT +1. The time now is 05:30 PM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
RadioBanter.com