| Home |
| Search |
| Today's Posts |
|
#4
August 9th 03, 07:39 PM
|
|||
|
|||
N2EY wrote: In article 3f347db8.1077907@nntp, (Space Charge) writes: Bondo+paint? Yes. It works. Put a piece of smooth tape on the front side and apply the bondo from the rear side. Let it set, remove tape, sand with very fine paper and paint. The results are as good as your craftsmanship. 73 de Jim, N2EY If the front panel is textured (as in the Collins S line or wrinkle finish) you can make a mold of the front using silicone 2 part mixes. When cured, place the mold over the hole and back fill with the epoxy. I have used this technique on S Line gear- and once painted with the Collins paints- it is virtually undetectable. Dale W4OP |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| FS: Connectors, Antennas, Meters, Mounts, etc. | Antenna | |||
| WTB-----------front panel for National NC-270 receiver | Boatanchors | |||
Threaded Mode
