RadioBanter - R-390

RadioBanter (https://www.radiobanter.com/)

- Boatanchors (https://www.radiobanter.com/boatanchors/)

- - R-390 (https://www.radiobanter.com/boatanchors/64476-r-390-a.html)

[email protected]

February 15th 05 02:29 AM

R-390

I need a filament resistor ballast tube for the 390 , any leads on
getting one? thanks Harold W4PQW

Mike Andrews

February 15th 05 02:36 AM

wrote:
I need a filament resistor ballast tube for the 390 , any leads on
getting one? thanks Harold W4PQW

Try the R-390 list; you'll have to subscribe to post, but the list is
full of good advice from people who know the rigs.

You can put a 47 Ohm 10% resistor in to replace the 3TF7 and probably
never have any filament regulation problems at all. It was put in
the circuit for situations where the 110 VAC power supply was *very*
uncertain.

The R-390 list is hosted at qth.net, and there's a signup page in the
tree based at http://www.qth.net/.

Replacements for 3TF7 are a FAQ, and you'll find leads if you really
want to spend the money. Just ask.

--
Mike Andrews, W5EGO/AE (!)

Tired old sysadmin, owned by one R-390 and 3 R-390A.

Joe	February 15th 05 02:58 AM

Chuck Ripple also makes solid state ballast replacements ...very reasonable
price.
You need regulation for SSB-CW RX

[email protected]

February 15th 05 11:21 PM

Thanks for suggestion,BUT, I am unable to locate Chuck Ripple. Who is
he? tnx Harold

[email protected]

February 15th 05 11:21 PM

Thanks for suggestion,BUT, I am unable to locate Chuck Ripple. Who is
he? tnx Harold

Mike Andrews

February 16th 05 03:29 AM

wrote:
Thanks for suggestion,BUT, I am unable to locate Chuck Ripple. Who is
he? tnx Harold

Try "Chuck Rippel", which I think may get you somewhere. His site is
http://www.r390a.com/.

--
Mike Andrews, W5EGO 5 wpm Amateur Extra, but working on it

Tired old sysadmin

Scott Dorsey

February 16th 05 03:10 PM

In article .com,
wrote:
Thanks for suggestion,BUT, I am unable to locate Chuck Ripple. Who is
he? tnx Harold

He writes for Electric Radio and lives down in Chesapeake VA. I think
he is at crippel @ exis.net. He does excellent work on the 390 machines
(even if he never could get the lowest band on mine to quiet down).
--scott

--
"C'est un Nagra. C'est suisse, et tres, tres precis."

Bill K

March 3rd 05 01:05 AM

I've seen these on "ebay" search on "R-390* collins"

wrote in message
oups.com...
I need a filament resistor ballast tube for the 390 , any leads on
getting one? thanks Harold W4PQW

All times are GMT +1. The time now is 09:31 PM.