Perhaps you could answer a few questions for me:

1. Is the knob dial marked 0-100?
2. What are the major (numbered) marks? Is it every 10, or 5?
3. What are the minor (ticked) marks? Is it every 1?
4. Is the knob attached to the dial? Or to the signal generator?

Thanks for the help.

Dave Goncalves
W1EUJ

On 10/16/05 5:34 PM, in article
,
" wrote:

Perhaps you could answer a few questions for me:

1. Is the knob dial marked 0-100?
2. What are the major (numbered) marks? Is it every 10, or 5?
3. What are the minor (ticked) marks? Is it every 1?
4. Is the knob attached to the dial? Or to the signal generator?

Thanks for the help.

Dave Goncalves
W1EUJ


Here's how mine is....

1. yes

2. every 10

3. every 1

4. to the dial

Don

Thanks Don.

Does this sig. gen require the use of a 3-6 dB pad on the output?

Dave Goncalves

On 10/16/05 6:04 PM, in article
,
" wrote:

Thanks Don.

Does this sig. gen require the use of a 3-6 dB pad on the output?

Dave Goncalves


It doesn't require a pad. This one came with a 20dB pad and a terminated
connector. I recall another one I used a lot that did have a pad (6 dB I
think) and there were calibration marks on the output attenuator that would
allow you to calibrate with or without the pad. For some reason we always
used the pad. It was probably a better match.

Don