"Brian Denley" wrote in message
...
Uncle Peter wrote:
Always do a "mechanical alignment" before doing an electrical one.
That is: check for loose couplers between the dial drives and caps,
make sure the dial pointer physically stops at the correct points at
the rotational stops... That the tuning capacitor plates are fully
unmeshed or meshed at the rotational stops (or as shown by the
manufacturer).

The Trimmer caps SHOULD allow you bring the high
end of the bands into calibration regardless of other issues... The
low end of the band alignment is usually set by the coil slug(s).

Pete



AND the coils and caps interact: if you adjust one significantly, you
have
to re-adjust the other. ALSO: if you are doing this with a sig gen, make
sure you are locking onto the actual freq, not some other mixer component
(happened to me).
--
Brian Denley
http://home.comcast.net/~b.denley/index.html



Interaction, true. However, if I recall, adjust the low end (coils) first.
The trimmers have least effect at the low end where the coils have effect
everywhere.

Starting like this usually means you won't have to do but this once. This is
predicated on the assumption that you are starting with a radio that has
been previously tuned and just needs touch-up; because the trimmer will be
"close".

73, Steve, K9DCI