Learn How VoiceMax Increases Your Transmission Range...
 

http://www.telstar-electronics.com/d...evelopment.htm

Learn How VoiceMax Increases Your Transmission Range...
 

"Telstar Electronics" wrote in message
ups.com...
http://www.telstar-electronics.com/d...evelopment.htm

You appear very confused over the technical terms you are using. The
misleading description doesn't fool anyone that works with radio.
The only thing that will increase range is more power or a better aerial
and/or location. You will find that the oscilloscope required to correctly
set this device with each radio would be put to better use setting the radio
without it in the first place.
Why do CBers still insist on having overdeviated signals claiming that range
will be increased? It causes a lot of splattering and most other radios
with narrow filtering will simply cut the signal thinking it is "bleedover"
as you call it.
On AM your radio will still clip the signal as it will on SSB if this extra
compressor is set incorrectly.

The only thing to do would be to modify the radio completely and remove the
TX audio conditioning circuits and replace them with this board.

I would say it's not required, certainly not in a modern radio. It will
decrease performance.

Learn How VoiceMax Increases Your Transmission Range...
 

"Telstar Electronics" wrote in message
ups.com...
http://www.telstar-electronics.com/d...evelopment.htm


I have never experienced someone claiming to run a company that only has ONE
product on offer - and is acting as a re-seller !

What have you actually designed and made rather than bought as kits from
manufacturers to re-sell to the public?

Learn How VoiceMax Increases Your Transmission Range...
 

Rob wrote:

"Telstar Electronics" wrote in message
ups.com...

http://www.telstar-electronics.com/d...evelopment.htm


You appear very confused over the technical terms you are using. The
misleading description doesn't fool anyone that works with radio.
The only thing that will increase range is more power or a better aerial
and/or location. You will find that the oscilloscope required to correctly
set this device with each radio would be put to better use setting the radio
without it in the first place.
Why do CBers still insist on having overdeviated signals claiming that range
will be increased? It causes a lot of splattering and most other radios
with narrow filtering will simply cut the signal thinking it is "bleedover"
as you call it.
On AM your radio will still clip the signal as it will on SSB if this extra
compressor is set incorrectly.

The only thing to do would be to modify the radio completely and remove the
TX audio conditioning circuits and replace them with this board.

I would say it's not required, certainly not in a modern radio. It will
decrease performance.


Hello Rob:

Wow what a bunch of negative vibs.

You bet it will increase distance, so will a linear amplifier, and a
better and higher antenna. As for the overmodulated signals, sure I hear
all the time, even on the lower bands. Shouldn't be a biggie.

We use to put a Diwa 440 speech processor on our CB Rigs, years ago. And
they worked great on AM and SSB, way more on SSB of course. You could
cut thru the skip with the processor on, and we didn't use no
oscillioscope. But there was some honking linears out there tho.

Jay in the Mojave

Learn How VoiceMax Increases Your Transmission Range...
 

On Jul 1, 3:44 pm, Jay in the Mojave wrote:
Rob wrote:
"Telstar Electronics" wrote in message
oups.com...

http://www.telstar-electronics.com/d...ductDevelopmen...

You appear very confused over the technical terms you are using. The
misleading description doesn't fool anyone that works with radio.
The only thing that will increase range is more power or a better aerial
and/or location. You will find that the oscilloscope required to correctly
set this device with each radio would be put to better use setting the radio
without it in the first place.
Why do CBers still insist on having overdeviated signals claiming that range
will be increased? It causes a lot of splattering and most other radios
with narrow filtering will simply cut the signal thinking it is "bleedover"
as you call it.
On AM your radio will still clip the signal as it will on SSB if this extra
compressor is set incorrectly.

The only thing to do would be to modify the radio completely and remove the
TX audio conditioning circuits and replace them with this board.

I would say it's not required, certainly not in a modern radio. It will
decrease performance.

Hello Rob:

Wow what a bunch of negative vibs.

You bet it will increase distance, so will a linear amplifier, and a
better and higher antenna. As for the overmodulated signals, sure I hear
all the time, even on the lower bands. Shouldn't be a biggie.

We use to put a Diwa 440 speech processor on our CB Rigs, years ago. And
they worked great on AM and SSB, way more on SSB of course. You could
cut thru the skip with the processor on, and we didn't use no
oscillioscope. But there was some honking linears out there tho.

Jay in the Mojave

A well designed (probably something telstar can't do) and properly
adjusted speech processor can boost the average signal some, but most
of the claims made are just hype. Most, if not all cbers will simply
crank the gain wide open because it makes the meter "swang" more so
they think they are getting a bigger signal, and I doubt they have a
clue as to what an oscilloscope is much less how to use one.

Learn How VoiceMax Increases Your Transmission Range...
 

Wow what a bunch of negative vibs.

You bet it will increase distance, so will a linear amplifier, and a
better and higher antenna. As for the overmodulated signals, sure I hear
all the time, even on the lower bands. Shouldn't be a biggie.

We use to put a Diwa 440 speech processor on our CB Rigs, years ago. And
they worked great on AM and SSB, way more on SSB of course. You could
cut thru the skip with the processor on, and we didn't use no
oscillioscope. But there was some honking linears out there tho.

Hello Jay,
Nice to see at least one person out there that understands radio
theory.
It's really amazing to me how many folks out there who operate
radios... but don't have a clue about the basics.

Learn How VoiceMax Increases Your Transmission Range...
 

On Jul 1, 5:32 pm, Telstar Electronics
wrote:

Hello Jay,
Nice to see at least one person out there that understands radio
theory.

Now if you could just understand a bit of radio theory.

It's really amazing to me how many folks out there who operate
radios... but don't have a clue about the basics.

Yep, that's cb land.

Learn How VoiceMax Increases Your Transmission Range...
 

A well designed (probably something telstar can't do) and properly
adjusted speech processor can boost the average signal some, but most
of the claims made are just hype. Most, if not all cbers will simply
crank the gain wide open because it makes the meter "swang" more so
they think they are getting a bigger signal, and I doubt they have a
clue as to what an oscilloscope is much less how to use one.- Hide quoted text -

Rob, if you understood this device at all you'd know that "cranking up
the gain" as you put it... is not possible. Only the limiting point
and noise gate have adjustment. As for you comment about "swang"...
that doesn't make any sense either. Since this speech processor holds
the modulation constant at 100%... actually there is no "swang" (that
must be a technical term of yours). You're doing well so far... lol

Learn How VoiceMax Increases Your Transmission Range...
 

On Jul 2, 12:04 pm, Telstar Electronics
wrote:
A well designed (probably something telstar can't do) and properly
adjusted speech processor can boost the average signal some, but most
of the claims made are just hype. Most, if not all cbers will simply
crank the gain wide open because it makes the meter "swang" more so
they think they are getting a bigger signal, and I doubt they have a
clue as to what an oscilloscope is much less how to use one.- Hide quoted text -

Rob, if you understood this device at all you'd know that "cranking up
the gain" as you put it... is not possible. Only the limiting point
and noise gate have adjustment. As for you comment about "swang"...
that doesn't make any sense either. Since this speech processor holds
the modulation constant at 100%... actually there is no "swang" (that
must be a technical term of yours). You're doing well so far... lol

Who is Rob?

Learn How VoiceMax Increases Your Transmission Range...
 

My 2p, I mean 2c.

The job of an audio processor is to increase the 'average level' level
of audio without changing the waveform. This can be done at both audio
and RF frequencies (RF speech processors are commonly found in many
ham transceivers).

However, even in the best processors a certain level of distortion is
generated. It's down to the designer and the user to keep this to a
minimum.

Yes, a scope is handy but I doubt your typical processor user would
know what to do with one.

Hi Jay, long time no speak. I hope your antennas are selling well.

Phil
Transmitters 'R' Us
http://www.transmittersrus.com London, UK