On Aug 26, 7:22 am, Telstar Electronics
wrote:
On Aug 26, 12:12 am,cmdr buzz
wrote:

To get the average modulation to 100% then you have to be
overmodulating.

Absolutely not!
If you hold the modulation right at 100%... guess what the average
is... lolwww.telstar-electronics.com

You can modulate over 100% on positive peaks, assuming the power
supplied to the final final amp stage being modulated can handle the
extra power without clipping the envelope, but you can't go over 100%
on negative peaks without distortion. So to get an average modulation
of 100% with reasonable signal quality you would have to over modulate
on positive peaks and never go over 100% on negative peaks. I doubt
your processor nor any cb can handle that. So you can't just "hold the
modulation at 100%".