| Home |
| Search |
| Today's Posts |
|
|
|
#1
October 27th 03, 12:40 PM
|
|||
|
|||
Can anyone tell me how to shorten a fiberglass whip from the bottom??? Is the
brass end just epoxied on?? Thanks Buck |
|
#2
October 27th 03, 01:24 PM
|
|||
|
|||
|
Buck,
Yes, the fibreglass rod is just glued into the base, then the inner conductor is soldered to the base. I assume it's epoxy but I can't say that for sure. 'Doc |
|
#3
October 27th 03, 10:06 PM
|
|||
|
|||
|
Thanks Doc....I have a couple layine around...I might try to shorten one of
them |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Doppler DF whip length | Antenna | |||
| Ohio/Penn DX Bulletin #649 | Dx | |||
| Ohio/Penn DX Bulletin #649 | Dx | |||
| Effect of whip diameter on resonant frequency | Antenna | |||
| Hygain 18AVT/WB Parts Traps, 80m coil whip etc. | Antenna | |||
Hybrid Mode
