RadioBanter

RadioBanter (https://www.radiobanter.com/)
-   CB (https://www.radiobanter.com/cb/)
-   -   Uniden Grant XL help needed please (https://www.radiobanter.com/cb/30466-uniden-grant-xl-help-needed-please.html)

ShaggyDAdawg December 2nd 03 05:13 AM

Uniden Grant XL help needed please
 
Hi -

I just got my hands on an old Grant XL and it looks like it's had a hard life.
Can someone tell me the correct transistors for the Driver, Final, and
pre-driver? Also, when I look at the inside with the SO239 jack facing away
from me, I see the Final on the left, the driver on the right, and then the
pre-driver hanging sideways on the back far off to the right? Is that the
correct order?

I'm trying to go from memory back when I had one of these rigs and it isn't
going so well :-) I saw the VCO can was messed with when some idiot put in
channels so I adjusted it and got the radio to receive and transmit now. But,
there's no power output on the wattmeter. However, when I put my Walkie-Talkie
nearby it got receive. So, I am convinced one of the three is shot; final,
driver, pre-driver. I have seen that two of those three have been replaced
previously...hmm.

Any help?

Thanks in advance!

ShaggyDAdogg

ONE37 December 2nd 03 09:44 AM

Final = 2SC1969C
Driver = 2SC2166 or 2SC1308
Pre-driver = 2SC1973
AM Regulator = 2SD1135 or 2SC1419
Voltage Regulator = MB 3788

Go hear to see a block diagram of your unit. It helped me out lots trying
to bring my ol' faithful back to life...
http://thexlclub.tripod.com/block.html

Take care...

ONE37

___________________________
To reply remove 'NOSPAM'



"ShaggyDAdawg" wrote in message
...
Hi -

I just got my hands on an old Grant XL and it looks like it's had a hard

life.
Can someone tell me the correct transistors for the Driver, Final, and
pre-driver? Also, when I look at the inside with the SO239 jack facing

away
from me, I see the Final on the left, the driver on the right, and then

the
pre-driver hanging sideways on the back far off to the right? Is that the
correct order?

I'm trying to go from memory back when I had one of these rigs and it

isn't
going so well :-) I saw the VCO can was messed with when some idiot put

in
channels so I adjusted it and got the radio to receive and transmit now.

But,
there's no power output on the wattmeter. However, when I put my

Walkie-Talkie
nearby it got receive. So, I am convinced one of the three is shot;

final,
driver, pre-driver. I have seen that two of those three have been

replaced
previously...hmm.

Any help?

Thanks in advance!

ShaggyDAdogg




ShaggyDAdawg December 2nd 03 11:52 AM

Excellent!

Thanks a bunch!!!


All times are GMT +1. The time now is 11:26 AM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
RadioBanter.com