Home |
Search |
Today's Posts |
#1
![]() |
|||
|
|||
![]()
Hello All:
Look at this e-bay auction for high temp Chimney's. Pictured is a 3CX5000 Tube. Yeah I know only a driver, hehehehe But I thought that the Chemney needed to have a .050 inch clearance between the ID (inside diameter of the Chemney) and the OD (outside diameter of the tubes plate. Allowing air to flow over the outside of the tubes plate OD surface. Or is it ok to use such "Silicon Rubber Chemneys" forcing all the cooling air thru the tubes inner plate cooling fins????? http://cgi.ebay.com/4CX5000-YC156-Si...cmd ZViewItem I have seen these Chemneys on production model amplifiers. Jay in the Mojave |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
FS Eimac 3-500Z Tube | Equipment | |||
FS Eimac 3-500Z Tube | Swap | |||
WTB: Eimac 3-500Z Tube | Boatanchors | |||
FS: Eimac 8877 tube, chimney & socket... | Swap | |||
FS: New in unopened box Eimac 450TH Tube $80 | Boatanchors |