Home |
Search |
Today's Posts |
#1
|
|||
|
|||
PSK-31 interface help needed for FT-817
I have a new Yaesu FT-817ND that I would like to use on PSK-31. According to the manual, one should be able to just connect the radio to the sound card without the need for any interface boxes such as the Rigblaster or Nomic. I have done this with my old Icom IC-735 and it worked pretty well up to about 10 watts of output, so one would think I should be able to get away with it running only 5 watts or less on the FT-817. My question is, have any of you all done that with success? As for connections, I must say that the FT-817ND manual is pretty bad at explaining how to hook it up. On page 38 the manual discusses SSB-based AFSK and shows the radio connected to a TNC. Then on page 39 under PSK-31, it says only to "Connect the FT-817ND to your computer's sound card or interface" without going into any detail on how to do tyat. I can only assume that the connections for audio are the same as shown on page 38, but they don't say that explicitly. The big question is, how is the PTT connected? Does that operate off of DCD or DTR on a serial port? If so, note that the voltage coming out of a serial port's handshake lines can be as much as +/- 15 volts and still be within the RS-232 spec. I find it hard to believe that +/- 15 volts on the PTT pin of the radio is OK. Of course, if the VOX circuit is active and can hear the audio from the data connector's Data In pin, then VOX could be used to switch to transmit mode. Do any of you know if VOX will work in PSK31 mode? Thanks and 73... Rick WA1RKT |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Need Info: Icom IC-900 Interface B | Swap | |||
RigMate Computer Interface Kits now Shipping | Digital | |||
ICOM IR-R-7100 Interface | Scanner | |||
FS: Echolink Interface - NEW! $55 | Swap | |||
Computer interface for IC-701? | Equipment |