Possibly it's not neutralised correctly?

Cheers.
Murray vk4aok

Dan/W4NTI wrote:

"Ralph Mowery" wrote in message
...

I have a Heath SB-200 amp that's behaving badly.
It works just fine on 80m through 15m, putting
out over 750 Watts PEP on 80m and 600 Watts PEP
on 15m. On 10m, it's not working right at all.
Instead of the plate current dipping at maximum
output, it's peaking at maximum output, and it's
very low when off resonance. This is just the
opposite of what I'd expect, and of what happens
on the other four bands. Maximum output on 10m
is only about 150 Watts PEP, with 100 Watts of

While probably not the problem, some later modle Heathkit amps were made
so
they would not operate on 10 meters. You have to change some wiring
around
the input tuned circuits or filtering. Not sure exectlly what, but a
friend
of mine had to do this and he was telling me about it. All that junk
about
not making amps that would work in and around the CB frequencies.



He said he had a SB-200, which by definition is 80-10. A SB-221 did not
operate on ten.

It is possible you are not tuning it correctly. On ten meters, things can
become quite 'squirly'. Put it into a good dummy load and experiment a bit.
Try reducing the load. Bring it up slow. Go between load and plate, see
how that goes.

Dan/W4NTI