|
Astron RS-20A Problem
|
Carl Franck wrote: Dear NewsReaders, I have a Astron RS-20A power supply that has started blowing its fuse even without a load. Until now it has been perfectly reliable. I would be much obliged for any advice as to what to look for first as I try to repair it. Sincerely, Carl KB2KDV Possibly a bad pass transistor. Try pulling each pass transistor out one at a time (or pull them all out and put them back one at a time until you blow a fuse) or if you have a transistor checker, check them. Another possibility, is you are getting an over voltage and the crow-bar circuit is activated. This could be caused by a problem in the regulator circuit. Possibly a bad LM723 regulator IC. These chips are pretty inexpensive and readily available. Andy WD4KDN -- Gun Control works!!! 3 million Holocaust victims can’t be wrong. |
Carl Franck wrote:
Thanks for the fast help Andy!, Carl : Dear NewsReaders, I have a Astron RS-20A power supply that has started : blowing its fuse even without a load. Until now it has been perfectly : reliable. I would be much obliged for any advice as to what to look : for first as I try to repair it. : Sincerely, Carl KB2KDV |
Carl Franck wrote:
Thanks for the fast help Andy!, Carl : Dear NewsReaders, I have a Astron RS-20A power supply that has started : blowing its fuse even without a load. Until now it has been perfectly : reliable. I would be much obliged for any advice as to what to look : for first as I try to repair it. : Sincerely, Carl KB2KDV |
I would first check the diodes between the transformer and filter cap.
To prevent causing more problems do service checking with a 100 watt light bulb in series with the AC line. This bulb normaly should glow bright for a second when power is applied (Chargine filter caps.) then fade to dim if all is ok. (no load) If it continues to be bright with no load on supply you still have problem. This limits current thru transformer. Saves fuses and transformers or circuit boards. good luck, Don |
I would first check the diodes between the transformer and filter cap.
To prevent causing more problems do service checking with a 100 watt light bulb in series with the AC line. This bulb normaly should glow bright for a second when power is applied (Chargine filter caps.) then fade to dim if all is ok. (no load) If it continues to be bright with no load on supply you still have problem. This limits current thru transformer. Saves fuses and transformers or circuit boards. good luck, Don |
N0DG wrote:
Thanks for those ideas Don. It's hard to believe that I threw away several fuses yesterday, I'm sure your last suggestion will save me real $. 73 de Carl KB2KDV : I would first check the diodes between the transformer and filter cap. : : To prevent causing more problems do service checking with a 100 watt light bulb : in series with the AC line. This bulb normaly should glow bright for a second : when power is applied (Chargine filter caps.) then fade to dim if all is ok. : (no load) : If it continues to be bright with no load on supply you still have problem. : This limits current thru transformer. Saves fuses and transformers or circuit : boards. : : good luck, : Don |
N0DG wrote:
Thanks for those ideas Don. It's hard to believe that I threw away several fuses yesterday, I'm sure your last suggestion will save me real $. 73 de Carl KB2KDV : I would first check the diodes between the transformer and filter cap. : : To prevent causing more problems do service checking with a 100 watt light bulb : in series with the AC line. This bulb normaly should glow bright for a second : when power is applied (Chargine filter caps.) then fade to dim if all is ok. : (no load) : If it continues to be bright with no load on supply you still have problem. : This limits current thru transformer. Saves fuses and transformers or circuit : boards. : : good luck, : Don |
Also check the bridge rectifier or the 4 diodes, don't recall what was in
there. Maybe one or all are shorted? Nitespark wrote: Carl Franck wrote: Dear NewsReaders, I have a Astron RS-20A power supply that has started blowing its fuse even without a load. Until now it has been perfectly reliable. I would be much obliged for any advice as to what to look for first as I try to repair it. Sincerely, Carl KB2KDV Possibly a bad pass transistor. Try pulling each pass transistor out one at a time (or pull them all out and put them back one at a time until you blow a fuse) or if you have a transistor checker, check them. Another possibility, is you are getting an over voltage and the crow-bar circuit is activated. This could be caused by a problem in the regulator circuit. Possibly a bad LM723 regulator IC. These chips are pretty inexpensive and readily available. Andy WD4KDN -- Gun Control works!!! 3 million Holocaust victims can’t be wrong. |
Also check the bridge rectifier or the 4 diodes, don't recall what was in
there. Maybe one or all are shorted? Nitespark wrote: Carl Franck wrote: Dear NewsReaders, I have a Astron RS-20A power supply that has started blowing its fuse even without a load. Until now it has been perfectly reliable. I would be much obliged for any advice as to what to look for first as I try to repair it. Sincerely, Carl KB2KDV Possibly a bad pass transistor. Try pulling each pass transistor out one at a time (or pull them all out and put them back one at a time until you blow a fuse) or if you have a transistor checker, check them. Another possibility, is you are getting an over voltage and the crow-bar circuit is activated. This could be caused by a problem in the regulator circuit. Possibly a bad LM723 regulator IC. These chips are pretty inexpensive and readily available. Andy WD4KDN -- Gun Control works!!! 3 million Holocaust victims can’t be wrong. |
I had two of those go out on me in a week, caused by a brown out. BOTH
cases, the bridge went bad. The brown out affected nothing else. Not the computers still on, radios, anything - but the Astron 20As fried. I'd definitely go for the Bridge to check. G.W. "Mark Russo" wrote in message ... Also check the bridge rectifier or the 4 diodes, don't recall what was in there. Maybe one or all are shorted? Nitespark wrote: Carl Franck wrote: Dear NewsReaders, I have a Astron RS-20A power supply that has started blowing its fuse even without a load. Until now it has been perfectly reliable. I would be much obliged for any advice as to what to look for first as I try to repair it. Sincerely, Carl KB2KDV Possibly a bad pass transistor. Try pulling each pass transistor out one at a time (or pull them all out and put them back one at a time until you blow a fuse) or if you have a transistor checker, check them. Another possibility, is you are getting an over voltage and the crow-bar circuit is activated. This could be caused by a problem in the regulator circuit. Possibly a bad LM723 regulator IC. These chips are pretty inexpensive and readily available. Andy WD4KDN -- Gun Control works!!! 3 million Holocaust victims can't be wrong. |
I had two of those go out on me in a week, caused by a brown out. BOTH
cases, the bridge went bad. The brown out affected nothing else. Not the computers still on, radios, anything - but the Astron 20As fried. I'd definitely go for the Bridge to check. G.W. "Mark Russo" wrote in message ... Also check the bridge rectifier or the 4 diodes, don't recall what was in there. Maybe one or all are shorted? Nitespark wrote: Carl Franck wrote: Dear NewsReaders, I have a Astron RS-20A power supply that has started blowing its fuse even without a load. Until now it has been perfectly reliable. I would be much obliged for any advice as to what to look for first as I try to repair it. Sincerely, Carl KB2KDV Possibly a bad pass transistor. Try pulling each pass transistor out one at a time (or pull them all out and put them back one at a time until you blow a fuse) or if you have a transistor checker, check them. Another possibility, is you are getting an over voltage and the crow-bar circuit is activated. This could be caused by a problem in the regulator circuit. Possibly a bad LM723 regulator IC. These chips are pretty inexpensive and readily available. Andy WD4KDN -- Gun Control works!!! 3 million Holocaust victims can't be wrong. |
Thanks very much G.W. and Mark, I suer appreciate the benefit of your
expeience, Carl Ghost Writer wrote: : I had two of those go out on me in a week, caused by a brown out. BOTH : cases, the bridge went bad. The brown out affected nothing else. Not the : computers still on, radios, anything - but the Astron 20As fried. I'd : definitely go for the Bridge to check. G.W. : : : "Mark Russo" wrote in message : ... : Also check the bridge rectifier or the 4 diodes, don't recall what was in : there. : Maybe one or all are shorted? : : Nitespark wrote: : : Carl Franck wrote: : Dear NewsReaders, I have a Astron RS-20A power supply that has started : blowing its fuse even without a load. Until now it has been perfectly : reliable. I would be much obliged for any advice as to what to look : for first as I try to repair it. : Sincerely, Carl KB2KDV : : Possibly a bad pass transistor. Try pulling each pass transistor out : one at a time (or pull them all out and put them back one at a time : until you blow a fuse) or if you have a transistor checker, check them. : Another possibility, is you are getting an over voltage and the : crow-bar circuit is activated. This could be caused by a problem in the : regulator circuit. Possibly a bad LM723 regulator IC. These chips are : pretty inexpensive and readily available. : : Andy : WD4KDN : : -- : Gun Control works!!! 3 million Holocaust victims can't be wrong. : : : |
Thanks very much G.W. and Mark, I suer appreciate the benefit of your
expeience, Carl Ghost Writer wrote: : I had two of those go out on me in a week, caused by a brown out. BOTH : cases, the bridge went bad. The brown out affected nothing else. Not the : computers still on, radios, anything - but the Astron 20As fried. I'd : definitely go for the Bridge to check. G.W. : : : "Mark Russo" wrote in message : ... : Also check the bridge rectifier or the 4 diodes, don't recall what was in : there. : Maybe one or all are shorted? : : Nitespark wrote: : : Carl Franck wrote: : Dear NewsReaders, I have a Astron RS-20A power supply that has started : blowing its fuse even without a load. Until now it has been perfectly : reliable. I would be much obliged for any advice as to what to look : for first as I try to repair it. : Sincerely, Carl KB2KDV : : Possibly a bad pass transistor. Try pulling each pass transistor out : one at a time (or pull them all out and put them back one at a time : until you blow a fuse) or if you have a transistor checker, check them. : Another possibility, is you are getting an over voltage and the : crow-bar circuit is activated. This could be caused by a problem in the : regulator circuit. Possibly a bad LM723 regulator IC. These chips are : pretty inexpensive and readily available. : : Andy : WD4KDN : : -- : Gun Control works!!! 3 million Holocaust victims can't be wrong. : : : |
Carl Franck wrote:
: Dear NewsReaders, I have a Astron RS-20A power supply that has started : blowing its fuse even without a load. Until now it has been perfectly : reliable. I would be much obliged for any advice as to what to look : for first as I try to repair it. : Sincerely, Carl KB2KDV Thanks again folks for all the super help and insight. I first did as Mark, Don and Ghost Writer suggested. Sure enough, I have one of the two bridge rectifiers shorted. I just got its replacement. I hope I can be 1/10 as helpful to someone soon as you all you guys have been for me. Happy New Year, Carl KB2KDV |
Carl Franck wrote:
: Dear NewsReaders, I have a Astron RS-20A power supply that has started : blowing its fuse even without a load. Until now it has been perfectly : reliable. I would be much obliged for any advice as to what to look : for first as I try to repair it. : Sincerely, Carl KB2KDV Thanks again folks for all the super help and insight. I first did as Mark, Don and Ghost Writer suggested. Sure enough, I have one of the two bridge rectifiers shorted. I just got its replacement. I hope I can be 1/10 as helpful to someone soon as you all you guys have been for me. Happy New Year, Carl KB2KDV |
| All times are GMT +1. The time now is 09:06 PM. |
Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
RadioBanter.com