About Us

April 13th 04, 09:44 AM

In article ,
says...
I have an R-2000 and 830S by Kenwood.
Both radios do not receive when plugging in coax connectors into the
S0-239 receptacles. I've eliminated the cables as the problem. I
believe it is possible salt air corrosion internally in both radios.
The signals and noise drop out completely when screwing in the PL-259
connectors all the way in and tightening them down. When they are only
half way plugged in I get normal reception when wiggling the cable but
they are not screwed in completely and not making a good electrical
connection. I lived on the beach and sometimes would open the windows
for ocean breezes. The 830S was right next to the open window and the
R-2000 was sitting on a night table a few feet away from the open
windows. I've eliminated the cables themselves and suspect salt air
corrosion internally in both radios.

Is there a spray contact/solder connection cleaner available on the
market that might help solve this problem?

Recently I had the S0-239 replaced onthe 830S and still have the same
reception problem. The noise and signals drop out completely in both
radios when screwing in the coax connectors (PL-259) completely.

Thanks for the help!

73's
K4JDP-John

Like another poster said, this is a symptom of an antenna/cable problem.
Take a piece of wire, and wad one end up and jan it into the center of
the SO-239. I bet both radios receive just fine. When my best antenna's
coax filled up with water after cracking due to old age/sun damage, it
cut the signal by at least 90% with the connector's shell connected, but
with just the center pin connected, it worked fairly well, for recieve.

I would be willing to bet a good amount of money there is nothing really
wrong with yuor radios..

BDK

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Single ground	Bill Ogden	Antenna	26	November 25th 04 03:47 AM
Station Grounding	ku4yp	Antenna	32	September 10th 04 04:18 PM
Antenna mast grounding question	Mike Ekholm	Antenna	25	December 5th 03 07:26 AM
Grounding question - this is wierd.....	John Passaneau	Antenna	17	August 31st 03 06:42 AM
RECEIVERS, Mil & Ham, FS	milradio	Equipment	0	August 11th 03 08:50 PM

Menu

About Us